CB Link -- FS-8700-23
FieldServer Driver - Serial
A communications interface solution for
Description:
The CB-Link driver allows the FieldServer to transfer data to and from devices over RS-485 using CB-Link protocol interfacing from the Cleaver Brooks Hawk controller (or the EC78XX Honeywell Link) to other devices. The FieldServer can accept any information transmitted by the CB Hawk, including:
- Program, operate, auto, man, rem modes
- Flame failure
- Gas pressure Sensor high/low
- Fuel selection
- Atomizing air off
- Steam pressure, water temperature, oil pressure sensor information
- Lockout and pre-ignition interlock
- AC line frequency
- Excess AC line noise
- Damper motor
- Replace battery
- Fuel selection, recycle limits, oil pressure, oil temperature, lockout/interlock, open oil drawer hold
- Standby, prepurge, pilot ignition, fuel change, main ignition, run, post purge, safety shutdown
- Low fire cutoff, flame detected, test switch, damper motor holds
- Call CB service.
Formal Driver Type: Serial, Server Only
Connection type: RS-485
Devices Tested:
- Cleaver Brooks Hawk
- EC78XX Honeywell Link
