CB Link -- FS-8700-23
FieldServer Driver - Serial

A communications interface solution for

Description:

The CB-Link driver allows the FieldServer to transfer data to and from devices over RS-485 using CB-Link protocol interfacing from the Cleaver Brooks Hawk controller (or the EC78XX Honeywell Link) to other devices. The FieldServer can accept any information transmitted by the CB Hawk, including:

• Program, operate, auto, man, rem modes
• Flame failure
• Gas pressure Sensor high/low
• Fuel selection
• Atomizing air off
• Steam pressure, water temperature, oil pressure sensor information
• Lockout and pre-ignition interlock
• AC line frequency
• Excess AC line noise
• Damper motor
• Replace battery
• Fuel selection, recycle limits, oil pressure, oil temperature, lockout/interlock, open oil drawer hold
• Standby, prepurge, pilot ignition, fuel change, main ignition, run, post purge, safety shutdown
• Low fire cutoff, flame detected, test switch, damper motor holds
• Call CB service.

Formal Driver Type: Serial, Server Only

Connection type: RS-485

Devices Tested:

• Cleaver Brooks Hawk
• EC78XX Honeywell Link